Filename: OAK_REGN

About the Forest Health Monitoring (FHM) Program:
The FHM program is managed by the USDA Forest Service (FS) in
cooperation with other program participants. Funding comes largely from
the FS and the U.S. Environmental Protection Agency.  Other participants
include State Forestry and Agriculture agencies, the USDI Bureau of Land
Management, the Tennessee Valley Authority, the USDA Natural Resources
Conservation Service, and several universities. The National Association
of State Foresters provides essential program support, guidance, and
assistance. Detection Monitoring, the most extensive of FHM's three
monitoring activities, is designed to provide data to determine baseline
or current conditions of forest ecosystems, and to detect changes and
trends over time. This information is analyzed to determine if detected
changes are anticipated, and if those changes indicate improving forest
health or are cause for concern, warranting additional evaluation.
Detection Monitoring covers all forested land and has two components:
(1) the on-frame component, which is measurements made on the FHM
network of permanent plots; and (2) the off-frame component, which is
forest surveys made off of the FHM plot network and includes forest
insect, disease, and other stressor effects. (References: The Forest
Health Monitoring National Brochure, and the FHM Fact Sheet Series.
Available at the Forest Health Monitoring National Office, P.O. Box
12254, Research Triangle Park, NC, 27709)

Coverage:
FHM uses the EMAP sampling grid, which is formed from a triangular grid
of sampling points. The FHM ground plots are approximately 1-hectare in
size and contain 4 subplots approximately 1/60 hectare in size. Ground
plots are approximately 27 km apart. (Reference: Stevens, D.L. 1994.
Implementation of a national monitoring program. J. Environ. Manage.
42:1-29.)

About the Index/Measurements:

Oak trees ò 1 inch (2.5 cm) and < 5 inches (12.7 cm) dbh (saplings) are
considered advanced regeneration. (dbh = the diameter at breast height
and is the diameter of the tree measured at 4.5 ft (1.37 m) above the
forest floor on the uphill side of the tree.)

Complete information about the measurements can be found in the Forest
Health Montioring Field Methods Guide (Tallent-Halsell, N. (editor).
1994. Forest Health Monitoring 1994 Field Methods Guide. EPA/620/R-94/027. U.S. Environmental Protection Agency, Environmental Monitoring
Systems Laboratory, Las Vegas, NV.)


Definition of Data Set Variables (in the order they appear in the data
set):

HEX -  the unique 7-digit code assigned to each 40 km2 hexagon.

MAP1 - (n = 62) Data for northern red oak (Quercus rubra) and black
       oak (Quercus velutina) as defined by the following codes:

       1  >300 trees/acre of advanced oak regeneration
       2  1-300 trees/acre of advanced oak regeneration
       3  0 trees/acre of advanced oak regeneration

MAP2 - (n=84) Data for other oak regeneration (other = all oaks other
       than northern red or black oak) as defined by the following
       codes:

       1  >300 trees/acre of advanced oak regeneration
       2  1-300 trees/acre of advanced oak regeneration
       3  0 trees/acre of advanced oak regeneration
       4  sites with no oak species